Baby Lock Jewel BL J18 Manuale delle Istruzioni Scaricare il pdf (Pagina 14)

Cluster LED Pin Light

Installation and/or

Replacement

e Cluster LED

(Figure 7) pin lights

are located on the

underside of the

front handles. While

LED lights have

a very long life

expectancy, oc-

casionally you may

need to replace one

or you may choose to add more Cluster LED pin

lights for additional lighting (available from your

Baby Lock retailer). You may add up to 10 addi-

tional LED Clusters on the front handles if desired.

Removal:

1. Shut o the power to the machine.

2. Grasp the Cluster LED pin light by the base of

the cluster with your ngertips.

NOTE: Do not grasp the LEDs themselves, as

they may break.

3. Pull straight downward without twisting (slight

rocking back and forth may be required).

4. If you are unable to remove the lights with your

ngers, you may use an extraction tool or a pair of

needle-nose pliers to carefully grasp the base of the

light cluster and pull downward.

Installation:

1. Shut o the power to the machine.

2. Insert the new Cluster LED pin light, matching

the three pins with the three holes in the receptacle

(orientation is not critical).

3. Press rmly until the LED pin light is fully

inserted (the base will be against the metal closing

plate of the handle).

Installing Rear Handles

CAUTION: Check that the Baby Lock Crown Jewel is un-

plugged from the electrical outlet. All power to the machine

must be turned o when installing the back handles. Failure to

do so can result in damage to the machine.

IMPORTANT NOTE: Care must be taken to not pinch the rib-

bon cable under the handle when it is tightened to the machine.

e rear handles already come mounted by three Allen screws into an

“L” bracket. Line up the two holes in the “L” bracket with those on the

rear of the machine. Slide the two short Allen screws into holes until

they stop. Hand tighten, and then use the 5.0mm Allen wrench to

securely fasten the handle to the back of the machine.

Once the two Allen screws are in place, plug the 9-pin ribbon con-

nector into the serial port underneath the rear handle (Rear Dia-

gram C, #32 page 7). Ensure the pins are lined up so they are not

damaged when the plug is pushed in. Push the plug securely in place.

NOTE: Aer the handles have been completely installed and

plugged in, test them by turning the Baby Lock Crown Jewel on/

o switch to “on”. e handles will run a self-test by briey display-

ing their version during boot up, and then the LED lights on the

front handles will illuminate. Aer the boot up is completed,

both LCD displays (front handle and rear handle) will display

the same menu. If nothing is displayed or if the lights don’t il-

luminate, check that the handle cable on the side of the machine

is plugged in securely, that your machine is turned on, and that

the power cord is plugged into the machine as well as a power

source.

Figure7

Figure6(ViewofBackHandles)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 45 46

Commenti su questo manuale

Nessun commento

Baby Lock Jewel BL J18 Manuale delle Istruzioni Pagina 14

Commenti su questo manuale

Prodotti e manuali riguardandi Macchine da cucire Baby Lock Jewel BL J18