Baby Lock Jewel BL J18 Manuale delle Istruzioni Scaricare il pdf (Pagina 17)

Laser Stylus Safety

and Use Guidelines

TheoryofOperation

e laser stylus projects a straight laser beam

visible as a dot on surfaces it hits. e laser dot is

used as a guide or stylus allowing you to stitch the

same pattern onto a quilt that is being traced with

the laser dot.

LaserOperationandUse

ere is not a separate on/o switch for the laser.

Power is supplied to the laser when it is plugged

into the Baby Lock Crown Jewel. Be sure the laser

is attached to the Baby Lock Crown Jewel and

pointed downward toward the table before con-

necting it to the port. Never point it in a direction

that would project the beam into someone’s eyes. If

the laser should cease to operate, check to ensure

the plug is rmly seated into the Baby Lock Crown

Jewel laser port.

LaserFocus/Laser

ImageSize

is high quality laser

is focusable. e laser

is focused by simply

grasping the threaded

housing surrounding

the lens and turning

clockwise or counter

clockwise (Figure 11).

(If you cannot see this

threaded housing, it

may be threaded too far

into the lens area. Take

an appropriate size screwdriver and turn counter

clockwise so the housing is visible, you can then

turn with your ngertips.) e laser image can

be adjusted bigger or smaller. e direction of

rotation needed is determined by the distance

of the laser from the intended focal plane.

Experiment by turning the threaded end to

achieve your desired focal size.

ClampAdjustment

e laser attaches to a mounting post. e post

may be vertical (installed on the top side, at

the front of the machine, in the post hole

(Back-Side Diagram B, #20 page 7) or

horizontal (installed toward the right back of the

machine in the hole marked as (Front-Side Dia-

gram A, #13 page 6). e Laser Stylus is designed

to articulate any direction by rotating the clamp

on the post and pivoting the laser up or down.

To make an adjustment, simply loosen the black

thumbscrews, position, and retighten.

LocationofLaserLabels

e label is attached to the case of the laser and

contains an arrow which indicates the direction

the laser light will shine when energized. e label

must remain in place on the laser. IMPORTANT

NOTE: Removal of the label will void the laser’s

warranty.

Figure11

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Commenti su questo manuale

Nessun commento

Baby Lock Jewel BL J18 Manuale delle Istruzioni Pagina 17

Commenti su questo manuale

Prodotti e manuali riguardandi Macchine da cucire Baby Lock Jewel BL J18