20
TopTension
Puckering, gathers and thread breakage occur
when the top tension is too tight. Loops and thread
nests occur when the top thread tension is too
loose. Tension may need to be adjusted depending
on the fabric, thread or batting you are using on
each project.
Important: Top tension should be adjusted
aer the bobbin case foundation tension
adjustment is made.
To adjust the top tension tighter, turn the tension
knob clockwise. To loosen the tension, turn the
tension knob counterclockwise. If the bobbin case
tension is adjusted a degree on the screw the top
tension may need to be adjusted a ¼ to ½ turn to
compensate or balance the tension.
Important Note: Before adjusting your top
tension remember to oss or pull the top
thread up into the tension discs or it will oat
outside the discs providing little or no top
tension. is could cause signicant tension
or nesting problems on the bottom side of
the quilt.
One of the joys of quilting with the Baby Lock
Crown Jewel is its ability to handle many dier-
ent types of threads. You can quilt with almost
anything, as long as you rst adjust your bobbin
tension, and then adjust the top tension to suit the
thread you’ve chosen.
Dark threads will be heavier (because of dye) than
light threads of the same weight. e type or brand
of thread may also aect tension settings. Each
time you change threads, you will need to check
your tension.
Maintenance
CleaningandLubricatingtheMachine
Only use light sewing machine oil in the Baby
Lock Crown Jewel. Internal oiling is not necessary
on the Baby Lock Crown Jewel except when the
machine is taken to a service technician for routine
maintenance and cleaning. e bobbin basket as-
sembly, however, needs regular lubricating. Failure
to keep the bobbin assembly lubricated can cause
severe damage to the machine. To lubricate, turn
o the machine. Clean around the bobbin assem-
bly with a so brush to remove lint.
Figure15
Put a very small drop of oil on
the hook in the bobbin assembly
(Figure 15). (Remove
bobbin and case before oiling).
e frequency depends upon
the usage of the machine.
Lubricating is recommended
before running the machine if
it has not been used regularly,
or every other bobbin change
if used frequently. Always sew
a scrap piece as oil may cling to
thread. Over oiling can cause
excess dripping from the bobbin
assembly. Lack of lubricant may
be noticed by a change in the
sound of the machine and will
aect stitch quality.
Cleaning the Touch Screen
Display
Never use any chemicals to
clean your display as this may
adversely aect the touch screen
response. Use a so cloth, damp-
ened with isopropyl alcohol
and gently wipe the display to
remove any marks.
Commenti su questo manuale