Baby Lock Jewel BL J18 Manuale delle Istruzioni Scaricare il pdf (Pagina 41)

3. Push bobbin securely on the split post.

NOTE: is should be a tight t—if too loose

the bobbin will slip and wind unevenly

causing inconsistent wind and tension issues.

Wrap thread around bobbin clockwise for several

rotations (Figure 4). Dial the variable-speed knob

to the right of center (Figure 5), then push the

power switch down into the “I” position. (“O” is o

and “I” is on.)

1. Loosen the small screw in the thread stand base. Install the

thread mast, making sure the top of the mast is centered over the

silver spool pin, then tighten the small screw (Figure 2).

NOTE: If the mast is not centered over the spool pin, thread

may catch on the side of the spool and negatively aect the

bobbin wind and/or break the thread.

2. Place the thread on the silver spool pin, pull the thread up

and through the thread mast. Pull the thread down through the

guide hole on the pre-tension assembly, going from the outside in

(Figure 3). Guide the thread between the tension disks and pull

thread to the bobbin (see arrows).

NOTE: e tension discs have been pre-set and tested during

manufacturing to ensure that the bobbin winds evenly and

rmly. If set too loose, the thread may tangle and if too tight,

winding may warp the bobbin, making the bobbin too high for

the bobbin case and preventing successful sewing.

Figure2

Figure4

Figure3

Figure5

Small

screw

Bobbin Winder

Instructions

1 2 ... 36 37 38 39 40 41 42 43 44 45 46

Nessun commento

Baby Lock Jewel BL J18 Manuale delle Istruzioni Pagina 41