Baby Lock Jewel BL J18 Manuale delle Istruzioni Scaricare il pdf (Pagina 15)

Inserting (or Changing)

the Needle

Figure8

Groove/

Front Side

Scarf/

Back

Side

DiagramD

(SideView)

IMPORTANT NOTE: Check the needle to

conrm it is fully inserted. e needle bar has

a sight opening above the needle bar clamp

screw—make sure the needle is touching the

top of the sight opening. If it is not, the

machine timing will be o and it may be

possible for the needle to collide with internal

parts causing damage not covered by warranty.

5. Carefully tighten the needle bar clamp screw.

Over tightening the needle clamp screw will result

in damaging the screw by stripping the threads.

Stripped threads are not covered under war-

ranty. A side eect of damaged threads from over

tightening the needle clamp screw is that it may

become dicult to insert the needle properly into

the needle bar. To avoid over tightening the screw,

while using the screwdriver, is once the screw no

longer turns freely is to then gently turn the screw-

driver until the screw is tightened snuggly.

NOTE: Changing the needle is recommended

for each new quilt loaded on the machine

or any time the needle becomes bent, dull

or burred.

1. Move the needle bar to the

highest position by turning the

handwheel counterclockwise

or pressing the needle up/down

control on the handles.

2. Turn all power to

machine o.

3. Loosen the needle bar clamp

screw with the appropriate

screwdriver (Figure 8).

4. Referring to Diagram D,

with the scarf (small recess area

on the back side of the needle,

just above the needle eye) facing

toward the rear of the machine

(handwheel location) and the

long groove down the front of

the needle facing the front of the

machine (bobbin case location),

push the needle all the way up

into the needle bar until it stops.

Check the sight opening to

verify that the top of the needle

can go no farther.

Needlesize Threadsize

16 monolament, hologram

100 wt. silk, 60 wt. poly,

50 wt. poly, 50 wt. cotton,

some 40 wt. threads

18 40 wt. cottons and poly,

30 wt. cottons and poly

20 Any thread 30 wt. and heavier

such as 12 wt., 19 wt., 30 wt.

Needle Guide

Needle

Bar

Clamp

Screw

CAUTION: Never leave machine unattended

when plugged in. Always unplug this machine

from the electrical outlet immediately aer using

and before maintenance.

Sight

Opening

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Commenti su questo manuale

Nessun commento

Baby Lock Jewel BL J18 Manuale delle Istruzioni Pagina 15

Commenti su questo manuale

Prodotti e manuali riguardandi Macchine da cucire Baby Lock Jewel BL J18