Baby Lock Jewel BL J18 Manuale delle Istruzioni Scaricare il pdf (Pagina 20)

NOTE: Before threading the needle test that

the machine is threaded properly and the

tension is correct by carefully pulling the top

thread. It should pull smoothly with light to

medium tension. If thread pulls freely with

no tension - rethread the machine.

4. Once the thread is in place, be sure that the

thread catches on the take up spring and then pull

it down under the stirrup thread guide D.

5. Bring the thread up and through the take-up

lever from back to front, and then down through

thread guide E.

6. Pull the thread down to the needle thread

guide and thread through the hole (F in Detail 3).

7. Make sure the thread is following the groove

down the front of the needle and insert thread

through the eye of the needle from front to back.

While pulling thread through the eye of the needle

be careful that the thread does not twist around the

needle.

IMPORTANT NOTES: e Baby Lock Crown

Jewel quilting machine does not have a

presser foot lever or top tension release like

a home sewing machine. On a home sewing

machine the top tension is released when

the presser foot is raised allowing the thread

to come freely out of the machine. When a

home machine is threaded the tension discs

are released and open to allow the thread

to easily fall between the tension discs. is

is not the case with the Baby Lock Crown

Jewel quilting machine. Consequently the top

tension is always tight and the tensions discs

are never open. erefore the thread must

be pulled up or “ossed” between the ten-

sion discs or it will stay outside the discs and

oat without tension, causing serious tension

problems and/or thread nests. It is also pos-

sible to bend the needle while it is threaded if

care is not taken while moving the machine

around the quilt because the top tension is

never released.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Nessun commento

Baby Lock Jewel BL J18 Manuale delle Istruzioni Pagina 20